Chapter 0: Parts and Tools
Parts
In addition to the included parts of the kit, the User will be required to obtain:
- 1 Micro SD card
- 1 Micro Type B USB cable
- 1 Tape measure
- Kapton tape
- At least 56mm of 1mm heat shrink
- Pusher (3D printed piece or a long screw that fits in the foot)
- Blue Loctite (for final sat)
- 1 Jig
The jig can be obtained from our documentation repository at our GitHub Organization.
Tools
The User will need the following tools prior to proceeding:
- Soldering Iron
- Lead Based Solder
- 18630 batteries (ideally Panasonic NCR18650B)
- Reflow Oven
- Low Temperature Lead Based Solder Paste
- T6 Torx Head Screwdriver
- T8 Torx Head Screwdriver
- Phillips Head Screwdriver
- Flush Cutters
- Sandpaper or Dremel
- M3 hole punch
- Hammer
- Needle nose tweezers
- Loctite
- Space-rated glue
- Multimeter
- Power supply
- Proper protective equipment
- Sandpaper or Dremel
If you are confused about any of the wiring or need references, refer to the following GitHub repositories: